Model: CH-05
Product Name: Car Phone Holder
Product Size: 56*35*20mm
Material: Zinc alloy
Suitable for: 4.5-7 inch mobile phone
Applicable Scenario: Center console,Windshield and flat surface
1.Use alcohol cotton pads to clean and dry the back of the phone
2.Tear off the plastic film on the front of the metal sheet and the protective film on the back, and install it on the back of the transparent protective case of the phone (press firmly for 1-2 minutes)
3.Press the bottom of the product bracket to open the bracket, tear off the bottom protective film, and stick it above the car dashboard (press to ensure the product is secure)
4.Place the back of the phone with the metal sheet installed on a magnetic bracket
1.Do not forcefully pull the clamp arm. Strong pulling will damage the internal structure of the product.
2.Mount the silicon based suction cups on the dashboard or windshield, making sure they are in a clean position.
3.The phone holder should be installed in place according to personal requirements before operation. It is strictly forbidden to operate and adjust the bracket during the operation.
